Page 1 of 2

VEMS has Vermont's First AWD Dyno

Posted: Wed Mar 07, 2012 2:39 am
by 6speed
Not only do we have Vermont's first AWD dyno, it's also Vermont's first load absorbing dyno. Need to investigate a lean spot at 3500 rpm and 6 psi of boost? No problem, we can hold the car at that exact location! This is an incredible diagnostic and tuning tool. In order to keep costs low, to you and to us, we have the dyno in Vermont approximately every other month. For 2012, it's March, May, July, September, and November. The Land and Sea hub dyno is top of the line and new to the market.

email jason@vems.us (or pm me here, or call 802-893-8788) to schedule an appointment.

Jason, the owner, has been involved with SCCV in varying capacities since 1999.

Stop by our new location at 158 Brentwood Drive, Suite 1 in Colchester (across Rt 7 from the Colchester/Milton Park and Ride we often meet at for karting/SLMP trips). We are open Monday and Wednesday eves from 6pm until around 11pm, Friday eve by appointment, and Saturday all day.

Dyno-only Rates:
Baseline - $100 2wd, $125 AWD
2wd hourly - $125
AWD hourly - $150
For half or full days, contact us.

Tuning:
VEMS Tuning - $75/hr
Subaru/Mitsubishi Open Source - $100/hr
Other standalones/flash tunes - $150/hr

An example: Subaru fuel injector replacement scaling with dyno verification, $250.

Important information to have when you contact us: wheel bolt pattern, 2wd or AWD, and the type of engine management (if you want it tuned).

All parts have a 5% Discount if you're a SCCV member. We stock fuel injectors, wideband sensors, wideband controllers, standalone ECUs, wiring, heatshrink, injector connectors, generic sealed connectors, boost control valves, and much more.

Thanks for considering us for your tuning and performance needs.
Image

Re: VEMS has Vermont's First AWD Dyno

Posted: Wed Mar 07, 2012 8:58 am
by Rabbit Farmer
Looking forward to seeing the new facility and dyno. Cabriolet needs some tuning to give it more go!

Re: VEMS has Vermont's First AWD Dyno

Posted: Wed Mar 07, 2012 11:20 am
by DaveP189
Good to know! =D>
(will pass the info around NNY for you, Jason)

Re: VEMS has Vermont's First AWD Dyno

Posted: Wed Mar 07, 2012 11:54 am
by sachilles
Need to get my rear diff bushing fixed, so I can get back on there.

Re: VEMS has Vermont's First AWD Dyno

Posted: Wed Mar 07, 2012 12:53 pm
by ryed
Need to save $$$ so I can get Joey to install the new turbo & downpipe, and get the outback tuned here! Hopefully by May...

Re: VEMS has Vermont's First AWD Dyno

Posted: Wed Mar 07, 2012 4:05 pm
by lawdogg
No way!! Awesome!! \:D/

Re: VEMS has Vermont's First AWD Dyno

Posted: Mon Mar 12, 2012 10:27 pm
by TSR53
Nice, I spy an Audi ur-quattro :D with a raised rear wing, european one-piece lights (Bosch units? or CibiƩs) and Narago Blue paint? Looks like a 1987 Audi 5000CS turbo quattro rim on the floor. Hmmm, needs 15x8 Ronal R8s...

Nice looking dyno, I'll have to stop by and meet and greet.

Re: VEMS has Vermont's First AWD Dyno

Posted: Tue Mar 13, 2012 5:03 pm
by sachilles
Going on the dyno tomorrow night with the Legacy.

Re: VEMS has Vermont's First AWD Dyno

Posted: Tue Mar 13, 2012 5:18 pm
by Rabbit Farmer
Dropping off my car this week.

I see Jeff's turbo Miata is down there also. :drive1:

Re: VEMS has Vermont's First AWD Dyno

Posted: Thu Mar 15, 2012 10:49 am
by sachilles
I don't think my legacy generated any love for Automatics :lol:
Jason got the legacy(Rosie) all nice and tuned.
I'm not sure how to describe it. Ludicrous, ridiculous fun. Substantially more power, noticeable at all times, but nice and smooth.
Think Rhonda would notice if I switched this motor to the race car, and put the race car motor in the legacy?

Shop is nice and roomy. Could probably have a nice soccer game in there.

Image